Lonsdor K518ISE

Lonsdor K518ISE
Lonsdor K518ISE


Ktag V2.13 FW6.070 ReadOpel Insignia ECUEDC17C59 in EEPROM

Check this article to learn how to reading Opel Insignia ECU EDC17C59 in EEPROM TC1767 using cheap V2.13 K-TAG ECU Programmer.

Vehicle to be tested
Opel Insignia

First,you need to get the unit --- V2.13 Ktag, €74.99 at obdtool.co.uk:
Material needed:
1. Cable 14P600KT02
2. 16-way rainbow ribbon cable 144300T105
3. Two 470 Ohm resistors
4. Solder wires

Note: Operation must According to the introduction.
Then You can start reading Opel Insignia ECU now!
Take apart the ECU from vehicle, open the ECU unit and connect ECU with KTAG
If you don’t know how to connect to ECU, you can choose “Plug-in 688...” to check detailed connection instruction, or it may cause damage to ECU, good luck for you!
Select vehicle model and ECU: OPEL-> Insignia -> BOSCH EDC17C59
After reading the instruction in detail and solder wires, successfully connect to ECU with KTAG
Then click OK to continue
Select the plug-in 688
Click “Read”
Ktag is identifying ECU...wait for a while
Then it is reading EEPROM...the operation may take several minutes
KTAG ECUProgrammer Reading ECU17C59 successfully! You can save the file
Finally, Remove the soldered wires and the resistors before re-installing the ECU to vehicle.
Good luck to you!